Thor400 User Guide

Step 1: Once your Thor400 is mounted, or if you have a complete Thor400 Controller box, follow this tutorial to setup your motor and refloat.

You would need the config files here, so please download them to your computer/ phone.
For Thor400, please load the Motor XML file for Motor, and Refloat file for Refloat as instructed in the video.
Config Files

 

Step 3: Once the above step is successful, please setup your IMU as shown in this video:

Technical Information:

Charging:

You would need a 32S Charger with a GX-16 4 Pin port that matches the following polarity. Please note the following is the polarity of the Connector on your THor400 Box:

 

 

Your charger pin 1 and 4 should be + and pins 2 and 3 should be - or ground.